CUTTING BOARD FOR SUBLIMATION
Size: almost 8 x 11.1”
Pressing directions:
Do NOT mirror image when printing transfer!
Place 1/2” felt pad pf 1/8” green heat conductive rubber mat on lower platen, cover with protective paper. Use heat tape to attach your transfer to the white side of the cutting board. Place the cutting board with the image side face down on top of pad or mat (textured side up). Cover with protective paper. Press for 4 minutes at 400 degrees with heavy pressure!! Note: if using green mat press for 5 minutes! Check to ensure image is fully transferred, continue pressing for 30 to 60 seconds more or until image has fully transferred! Cool cutting board face up and apply feet after the board has cooled completely! Note: when attaching feet, press firmly on each piece of rubber to activate the adhesive! Do not was for a minimum of 72 hours after application!
Note: paper may stick to board but will easily scrub off!
Size: almost 8 x 11.1”
Pressing directions:
Do NOT mirror image when printing transfer!
Place 1/2” felt pad pf 1/8” green heat conductive rubber mat on lower platen, cover with protective paper. Use heat tape to attach your transfer to the white side of the cutting board. Place the cutting board with the image side face down on top of pad or mat (textured side up). Cover with protective paper. Press for 4 minutes at 400 degrees with heavy pressure!! Note: if using green mat press for 5 minutes! Check to ensure image is fully transferred, continue pressing for 30 to 60 seconds more or until image has fully transferred! Cool cutting board face up and apply feet after the board has cooled completely! Note: when attaching feet, press firmly on each piece of rubber to activate the adhesive! Do not was for a minimum of 72 hours after application!
Note: paper may stick to board but will easily scrub off!
Size: almost 8 x 11.1”
Pressing directions:
Do NOT mirror image when printing transfer!
Place 1/2” felt pad pf 1/8” green heat conductive rubber mat on lower platen, cover with protective paper. Use heat tape to attach your transfer to the white side of the cutting board. Place the cutting board with the image side face down on top of pad or mat (textured side up). Cover with protective paper. Press for 4 minutes at 400 degrees with heavy pressure!! Note: if using green mat press for 5 minutes! Check to ensure image is fully transferred, continue pressing for 30 to 60 seconds more or until image has fully transferred! Cool cutting board face up and apply feet after the board has cooled completely! Note: when attaching feet, press firmly on each piece of rubber to activate the adhesive! Do not was for a minimum of 72 hours after application!
Note: paper may stick to board but will easily scrub off!